![]() ![]() Short answer: you don’t need the enable pin - and sorry for that. This mod is also feasible for a IC-7300 without the need of replacing the USB hub - the idea is just the same: Tap the voltages, the signaling, the IF output, hook it to the panadapter board, lodge the SDR in the radio, solder the SDR USB port to the USB hub - And result is going to be pretty much the same! The project was featured in Hackaday and RTL-SDR Blog.Ī demonstration of the working setup can be watched in the below video: The enterprise is 100% open source with schematics, BOM, board gerbers available at and thorough documentation is available at. Well, no - This time we are talking about a FT-991A.Īfter a few months of research, discussion and a lot of constructive feedback, I was able to actually embed a RTL-SDR dongle inside the FT-991A and exporting its interface through the radio's USB port - No external extra wires, ports or whatsoever - Everything coming down neatly from the existing USB port, along the CAT and Audio interfaces. Of course some may say that we are talking about some Apache Labs or Flex Radio. ![]() ![]() ![]() The digitalized spectrum I/Q SDR output to be used with a Panadapter or with your favourite GNURadio application? With no external wires, jumper wires or a external SDR? What about you plugging your radio's USB port to the computer and obtaining the Audio, the CAT and. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |